7382zip -

If you are designing a physical part, "drafting" refers to adding a slight taper (angle) to vertical faces so the part can be removed from a mold easily.

For plastic injection molding, a minimum draft of 3∘3 raised to the composed with power is generally recommended to prevent part damage. Drafts - 2025 - SOLIDWORKS Design Help 7382zip

Used for more complex split molds where the taper must go in two directions from a specific line. If you are designing a physical part, "drafting"

Below are the most likely ways to "draft a solid feature" depending on which software you are using. 1. In 3D Modeling (SOLIDWORKS / CAD) Below are the most likely ways to "draft

When creating a "Solid Boss/Extrude," you can enable the Draft icon directly in the PropertyManager to add an angle while the solid is being created.