Vl_13.set_onf.1.var Instant

Re-run the validation script under 80% load to verify if the flag triggers prematurely.

Reset the VL_13.Set_OnF.1.var to 0 only after physical inspection of the wiring harness. VL_13.Set_OnF.1.var

The variable VL_13.Set_OnF.1.var was triggered during the . This flag is programmed to remain 0 (False) during nominal operations and switch to 1 (True) upon a secondary component failure detection. Initial State: 0 (Standby) Trigger Event: Voltage drop detected in Terminal Block 13. Final State: 1 (Active/Fail) 2. Performance Metrics Re-run the validation script under 80% load to

The activation of the .Set_OnF (Set On Fail) flag suggests a hardware-level interrupt. Preliminary logs indicate that the module encountered a synchronization error with the master clock, forcing the sequence into a "Safe State" to prevent cascading thermal damage. 4. Recommended Actions This flag is programmed to remain 0 (False)

The following table illustrates the variance in system behavior leading up to the variable state change: Baseline Value Recorded Value Load Cycle (Hz) Thermal Output (°C) Response Latency (ms)